Walkin Wheels Dog Wheelchair / Cart

What’s In the Box?

• 1 Frame
• Side extenders
• Width Connectors
• 1 Set (2) Foam Wheels or for Pneumatic Air-Filled Tires (add $49.00-$69.00)
• 1 Front Harness with Sleeves
• 1 Set Leg Rings Rear Support Saddle
• 1 Belly Belt
• 2 Stirrups
• 1 Instruction Manual

Foam Wheels vs Air Tires

Foam Wheels
Standard with all wheelchairs
The foam wheels are great for all terrains. They feature a dense foam interior with an outer rubber layer. These wheels will not puncture, wear extremely well, and are easy to clean.
Sizes available: 4″, 8″,12″ & 16″

Air Tires
Optional Upgrade
The air tires are for very active dogs that like to go hiking on rough surfaces. These tires are like mountain bike tires. They have a nice deep tread and a replaceable inner tube. There is an additional $49.00-$69 fee for these tires.
Sizes available: 12″ & 16″.

What Comes With the Walkin’ Wheels Dog Wheelchair

The Parts of the Dog Wheelchair

Frame:

The Frame itself is powder-coated aluminum. It will not bend, break, or rust. The molded plastic knuckles attach the frame and the legs in such a way they cannot possibly slip. 360 degrees of ‘teeth’ hold the knuckle in place at every point.
On the side of the knuckle, a spring-loaded turning cap allows you to loosen the knuckle and swivel the legs up or down.

About three turns of the knob should be enough. Do not turn the dial so that it comes all the way off — although if you do, it is easy to screw back on.

Width Connectors: (2 connectors with Medium frame) ( 1 with Large Frames)

The width connector connects the left and right side of the frame together.

Length Extenders: (2 extender sets with regular medium frame)( 1 with the large frame)

The length extenders connect the front harness in place with the cart. The length extenders are adjustable.

The Front Harness: The dog’s head goes between the blue and black strap, and the red strap goes around the chest and clips on the side of the harness.

The shoulder pads (A) are made of neoprene and keep the straps and buckles from causing discomfort for the dog. The red strap (B) goes behind the front legs, underneath the chest and holds the front harness securely when clipped into the side panel. Neoprene comfort sleeves wrap around the straps for the dogs comfort. It is best to take comfort sleeves off while adjusting the three straps snug to your dog. Comfort sleeves can be cut in half if they are too long.

The only difference between the regular and large front harness is the length of strapping. The girth of the regular harness is 48″ max.

Parts of the Wheel Kit

Struts:

One set comes in wheel kit.
Struts are what the wheels are attached to which then snap into the cart. The struts are adjustable within a range of three inches. The struts come in 4 different sizes: 6, 9, 12, 15 & 18" inches. Each wheelchair comes with an appropriate set of struts based on your dog’s Fold of Flank measurement.

Leg Rings (Shown Attached to the Dog Wheelchair)

The hindquarters of the dog are held in place by the leg rings, or our rear harness support system. We have found that most dogs adapt quickly to the leg rings. The leg rings are included with the cart.

The leg rings that come with your Walkin’ Wheels work great used as a lifting harness. The excess strapping can be Velcro together to make handles on each side.

Foam Wheels:

One set comes in wheel kit.

Ranging from 4", 8" 12" and 16"

Each Wheelchair comes with an appropriate set of wheels based on your dog’s Fold of Flank measurement. The 12″ and 16″ wheels are outfitted with bearings.

Air-Filled Pneumatic Tires: Available in 12" or 16"(Optional)

Air-filled pneumatic tires are an optional item for active dogs, improved traction, and off-road use. Available for your dog wheelchair for an additional $49-$69

The Belly Belt will help support your dog’s back. Highly recommended for:
1. Dogs with a long back
2. Overweight or elderly dogs
3. Dogs with curvature of the spine
4. Dogs with disc problems

One Belly Belt is included with each wheel kit.

Stirrups:

These are used to keep your animal’s back legs from dragging on the ground if the legs are paralyzed or weak. The length of the stirrups can be easily adjusted by moving the clip down on the rope and re-tying the knot.

The Manual & DVD:

This literature and DVD will be included with the cart. Please watch the DVD before setting up the cart to give you a full understanding of how the cart works. If you have any questions, you should call Handicappedpetscanada.com, 778-809-7421.

Tool Kit:

The tool kit comes in a plastic bag and includes:

– Allen Wrench
– Set Screws (8) You only need to use 6 set screws total.
2 – bottom of the legs
2 – end of frame
2- width
You will see small holes where the set screws are attached. This will keep the frame from rattling and tightens everything up.

Facts, Answers and Questions

“Can my Pet Pee and Poop in the Wheelchair?”
Yes, that’s the point of the dog wheelchair — to help your dog get the exercise he needs… and do his business!

“Can my Pet Use his/her Rear Legs in the Wheelchair?”
Yes, we encourage your dog to use his/her rear legs as much as they can to maintain muscle mass and to get exercise. If the rear legs are paralyzed, then the stirrups will keep their legs from dragging.

“How Do I Measure My Dog?”
Click here to find out

“Is the wheelchair easy to transport?”
This Wheelchair folds flat for easy transport. Fits in tote bag. (included)

“Will this wheelchair rehabilitate my dog?”
We have seen varying degrees of recovery with dogs using the wheelchair. Some dogs have been able to improve so much that they no longer needed the wheelchair. Every dog and disability are unique. While your dog is in the wheelchair they are getting physical therapy improving their physical and mental health.

“What is the return policy?”
It is our intention that every Walkin’ Wheels user be happy with their wheelchair. If you experience problems, please call us. Often we can help with a simple adjustment. If you feel the wheelchair is not for you, we can issue a RETURN MATERIALS AUTHORIZATION. Please note that wheelchairs returned without a return materials authorization will not receive credit. Please click here for full return policy

“How to tell if the Cart is Adjusted Properly”

When the cart is adjusted properly, the animal stands in a ‘natural’ position. Here’s what to check. Refer to the figure below.

A – Knuckle at the hips. If you were to draw an imaginary line from one knuckle to the other, the line would pass right through the dog’s hips… where the bone of the leg meets the bones of the body. If not, tighten harness and/or adjust length. Allow 1″ on each side between dog and black knuckle.
B – Front Support loop at the shoulder. The loop on the front harness that the bar goes through should be at the shoulder. Adjust the straps so that the loop is held firmly against the shoulder. Then clip into cart.
C – The dogs back needs to be straight or arched UP (slight hunch). In this photo the dog’s back is arched down a little. This is NOT correct and this dog needs the Belly Strap.
D – The back legs need to be just touching, or just off the ground, depending on the health of the back legs. If the dog wants to use his back legs, then allow his feet to touch lightly. This is often adjusted by tightening the straps that hold the harness to the frame – this brings the dog’s seat up. (Take the dog out of the harness before adjusting.) If the height of the harness cannot be changed, then lengthen the leg struts. Consider boots if the feet drag. Use the stirrups if the dog cannot use his back legs or the feet are dragging on the ground.
E – The horizontal bar needs to be level.

If you have tried all of the suggestions and are still having a hard time, please call us at 778-809-7421. Our staff will be happy to assist you.

The Fold of Flank (FOF)

If your dog cannot stand:

If your dog cannot stand, you can measure the fold of the flank when he is lying on his side. In order to get an accurate measurement, position the dog’s rear leg in a normal standing position: knee joint and hock joint will be slightly bent. Bend the dog’s foot at his ankle (like it would be if he was standing on his foot). In this picture the yardstick shows a FOF of 18 inches.

Do NOT stretch the dog’s leg and foot out as this will add several inches to the fold of flank and give you an inaccurate measurement.

Measurements to fit your pet into a Mini or Small cart:

Once you’ve got the wheelchair

If you’ve received your pet’s wheelchair and are not sure if you’ve got it set up properly, take a look at the example below:

A – Knuckle at the hips. If you were to draw an imaginary line from one knuckle to the other, the line would pass right through the dog’s hips… where the bone of the leg meets the bones of the body. If not, tighten harness and/or adjust length. Allow 1″ on each side between dog and black knuckle.
B – Front Support loop at the shoulder. The loop on the front harness that the bar goes through should be at the shoulder. Adjust the straps so that the loop is held firmly against the shoulder. Then clip into cart.
C – The dogs back needs to be straight or arched UP (slight hunch). In this photo the dog’s back is arched down a little. This is NOT correct and this dog needs the Belly Strap.
D – The back legs need to be just touching, or just off the ground, depending on the health of the back legs. If the dog wants to use his back legs, then allow his feet to touch lightly. This is often adjusted by tightening the straps that hold the harness to the frame – this brings the dog’s seat up. (Take the dog out of the harness before adjusting.) If the height of the harness cannot be changed, then lengthen the leg struts. Consider boots if the feet drag. Use the stirrups if the dog cannot use his back legs or the feet are dragging on the ground.
E – The horizontal bar needs to be level.

If you have tried all of the suggestions and are still having a hard time, please call us at 778-809-7421. Our staff will be happy to assist you.

Check out all of the options available for your pet’s new wheelchair!

From compatible lifting harnesses, to comfy vests, front end attachments and even skis! Walkin’ Wheels has thought of everything your dog needs to enhance his or her new mobility experience! Not to mention making life a little easier for you.

Walkin’ Wheels License Plates – From $29.95 Customize your pet’s Walkin’ Wheels with a personal license plate! These plates can be showcased on the back of your pet’s wheelchair. You can choose the background and text to appear on the license plate! Compatible with all Walkin’ Wheels sizes!Click here to learn more!

Click to enlarge

Rentals

If your pet just had a surgery, they may not need the wheelchair for a very long time or not sure if your pup will adapt? That’s why we offer pet owners a chance to rent one out rather than buy it. If this is you, give us a call at 778-809-7421 or send us an email and we’ll see if we have the right size for your pet in stock. You can get more details about this on our Rentals Page ( Click Here )